Saving Two Monitor Setup

I run the VC on one monitor and various Instrument windows on the other, I takes a while to setup everytime, I've tried saving the flight but that does not save the setup, any suggestions would be appreciated.

That's a surprise. Did you save as a "Flight" or under Flight Planner. I have several "Flights" saved, one per each aircraft I usually fly, and they are all set up for three monitors with GPS, RW weather, etc.

 

When I want to fly a specific aircraft, I call up the "Flight" associated with that aircraft, then designate the airport I want to use including runway or parking, plus the local time and season I choose, only then do I start the "Flight." Using that system everything is set up as I wish almost every time I fly.

 

One other point I didn't mention. Using the above mentioned method my left and right screens often initially have a smaller than screen size square which I have to manually click and drag to full screen-size. Which takes maybe five seconds per screen.

 

 

Good Luck,

 

Rupert