asmw72749 Posted February 18, 2015 Share Posted February 18, 2015 Just downloaded a SWA Boeing 737-800 today and it installed just fine. But then once I got to flying, it just wouldn't takeoff normally. I would go to pull up around normal takeoff speeds and the plane would just puff up smoke and not pull up. Then at about the end of the runway (250 knots by now) it finally takes off. Is this normal? I think there is something not right but I could always be wrong. If anyone could offer some advice about the issue, I would highly appreciate it. Thanks, Adam M. Link to comment Share on other sites More sharing options...
drobson Posted February 18, 2015 Share Posted February 18, 2015 Sounds like you need to adjust the trim settings. [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
mrzippy Posted February 18, 2015 Share Posted February 18, 2015 Is this a "wonderful" TDS model? If it is you will need 2-3 taps on the Numpad2 key for elevator trim. That should get you in the air at the proper speed and well before the end of the runway. Hey Darrel, does a tie go to the runner? Still thinking about a new flightsim only computer! Link to comment Share on other sites More sharing options...
asmw72749 Posted February 18, 2015 Author Share Posted February 18, 2015 Haha yes...this is the "wonderful" TDS model. Thanks for the help guys. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.