oldsalt Posted August 24, 2022 Share Posted August 24, 2022 I am trying to add some red runway numbers that are painted on the surface of the runway, usually at the hold short lines. I have the numbers in a dds format but they look backwards. I know about using ADE but I am not so good at making the draw polygon boxes and adding the numbers. Would really appreciate some help on this. It is very diffifult for me to learn the technique. If some one would please help me with this I will be most grateful Thanks Link to comment Share on other sites More sharing options...
il88pp Posted August 25, 2022 Share Posted August 25, 2022 turn .dds file 180 degrees clockwise. then re-save .dds file. then place in airport. or is it not that straightforward? [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
ianhr Posted August 25, 2022 Share Posted August 25, 2022 turn .dds file 180 degrees clockwise. then re-save .dds file. then place in airport. or is it not that straightforward? They'll still be "backwards", just not upside-down. [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
il88pp Posted August 27, 2022 Share Posted August 27, 2022 (edited) would rotate 180 then flip horizontal work? Then again, he says they "come out backwards". So maybe backwards input is no issue and flipping horizontal is not needed. (By the by... I think rotating 180 and flipping horizontal, give sthe same result as flipping vertical without rotating.:confused:) Edited August 27, 2022 by il88pp [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Recommended Posts