Jump to content

It’s been there all along


Recommended Posts

It’s been there all along.

I once thought that the HOLLYWOOD sign was forgotten.

I looked for it many times as I was trying to get a handle on the workings of this new Flight Simulator.

I could always see the POI marker but never the sign. I even posted about it.

If I remember right, a couple of other guys had the same problem.

One guy posted that you could download an add on.

I had to eat my words when I posted about other missing items.

Like the Washington Monument, buildings in NYC and a couple of other things

that I spoke about without being fully informed.

I got fairly good at fooling around with things in the data section of the GENERAL OPTIONS menu.

So I gave the HOLLYWOOD sign another shot.

I tweaked up the data and went hunting.

I found it right where it is supposed to be.

In FS X the sign is up high on the ridge.

In FS20 it is down below the ridge line where it belongs.

VFRguy

Link to comment
Share on other sites

I had a look for it after your previous post but couldn’t find it either.

I shall look again next weekend

 

Regards

Steve

Intel I9-13900K - Gigabyte Z790 Aorus Elite AX - 64Gb DDR5 5600Mhz - Asus RTX4090 ROG STRIX 24GB

3x 43” Panasonic 4k TVs - Corsair RMx 1200W PSU - 2 x 2TB M.2,  2 x 4TB SATA III and 1 x 4TB M.2 SSDs.

Pico 4  VR Headset - Honeycomb Alpha Yoke - Honeycomb Bravo Throttle Unit

Thrustmaster TPR Rudder Pedals - Saitek Throttles

Link to comment
Share on other sites

Yep, it's there! Take off from Santa Monica Municipal on 03, take a 020 or so heading for 9 miles and voila.

 

J-Louis

J-Louis Belard, 6 miles SW of KGAI

Dell XPS,8930, I-7 9700, 32GB DD4,

512 SSD, 2TB HD, 6GB GeForce GTX 1660

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...