jbearnolimits Posted December 5, 2019 Share Posted December 5, 2019 So I've asked this question a few times and it seems the answer is that it's an issue with FSX. I noticed the plane doing a side slip BUT it's coordinated and no wind. This results in landing with my tail left, my nose right, and the CG going straight down the runway. I have been having trouble explaining it so I FINALLY made a video to SHOW it. Could someone take a look just to confirm? https://youtu.be/C2ECvbvtdmU Link to comment Share on other sites More sharing options...
lnuss Posted December 5, 2019 Share Posted December 5, 2019 I know exactly what you're talking about, and it is indeed a flaw in FSX, or more properly in the setup of flight parameters for most aircraft. Most folks seem to not believe it happens, or think it's normal, but adjustments of yaw parameters in section 1101 of the .air file (especially "Yaw Moments" and "Side Forces") can take away the worst of it. However, it takes quite a bit of experimentation to correct the problem, and the correction is different for each aircraft. I've not done much with it myself, but a friend did a lot of experimentation and corrected it on several aircraft we both had. Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
jbearnolimits Posted December 6, 2019 Author Share Posted December 6, 2019 Yeah, I know you have mentioned it. I just thought it would be a good idea to show a video of it. Were you able to see the video just to confirm? Link to comment Share on other sites More sharing options...
lnuss Posted December 6, 2019 Share Posted December 6, 2019 How long (far?) before the video starts did you make a turn? Was it a left or right turn? Was the slip angle gradually decreasing? I hadn't watched the video before my first reply, relying on your description, but I have now, thus the questions above since in that short video I don't see the symptoms I expected. BTW, that isn't really a sideslip, as generally used in aviation terminology, though it was certainly sideways travel. Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
jbearnolimits Posted December 6, 2019 Author Share Posted December 6, 2019 The turn was made about 3 minutes prior. It was a left turn and the angle was steady. I have noticed that if I turn and then fly level it will still drift in the direction of the turn for about 1 minute and then suddenly it will stop drifting. But even the slightest turn to correct the path will cause it to drift again. But that is a full drift with the nose AND tail lined up. This video shows a combination of a bit of the drift AND with the nose and tail not lined up. Link to comment Share on other sites More sharing options...
jbearnolimits Posted December 6, 2019 Author Share Posted December 6, 2019 So it travels sideways even when it shows coordinated flight. Link to comment Share on other sites More sharing options...
lnuss Posted December 6, 2019 Share Posted December 6, 2019 OK, so "if I turn and then fly level it will still drift in the direction of the turn for about 1 minute and then suddenly it will stop drifting." indicates the problem I've described before, needing the yaw correction in the .air file. The other piece of it I don't know about at all, except that 1) I've never encountered it and 2) It almost has to be something related to that specific aircraft, but I don't know what. Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
jbearnolimits Posted December 6, 2019 Author Share Posted December 6, 2019 I wonder if it could be due to the p factor and torque. I noticed it has been pulling left on take off like a c172. It being a jet I would think it would act a little bit different. Link to comment Share on other sites More sharing options...
lnuss Posted December 6, 2019 Share Posted December 6, 2019 Jet engines don't have torque, and P-factor is something that affects propellers (uneven thrust), not jets. Whatever is pulling left on takeoff may be what's causing you to slide a bit in the air, also. Perhaps checking control calibration and control settings may help you find the problem. Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
jbearnolimits Posted December 7, 2019 Author Share Posted December 7, 2019 It looks like taking p factor and torque to easy stopped the take off issue. But still have the issue of sideways flight. I don't know, maybe I should just use x plane. Link to comment Share on other sites More sharing options...
lnuss Posted December 7, 2019 Share Posted December 7, 2019 On a jet? Wow! Strange... Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now