gazman Posted May 22, 2019 Share Posted May 22, 2019 Hello I have the AS Beaver working with all gauges in P3D v4.5. I have also installed a mod [to the panel.cfg] that replaces the existing DG [gauge07] with the Cessna C172 Heading Indicator. The Cessna gauge is visible only in the shift+1 and shift+2 views and not in the vc. This was working fine until the new gauge suddenly became distorted - see pic. There is no loss of functionality. For clarification the gauge should display in the black hole behind it. It's like looking at it through a fish-eye lens. I've reviewed all my settings and they are good. Does anyone have a suggestion as to a remedy? Thanks. Regards gazman Link to comment Share on other sites More sharing options...
Clutch Cargo Posted May 23, 2019 Share Posted May 23, 2019 Could it be you have "wideview" on? Link to comment Share on other sites More sharing options...
lnuss Posted May 23, 2019 Share Posted May 23, 2019 Gauge placement in the virtual cockpit isn't as simple as it used to be, at least for those aircraft which have "3D" panels, where some things are (if I understand correctly) built into the model. I've not messed with this myself, but have heard a few things, not enough to help you much. Larry N. As Skylab would say: Remember: Aviation is NOT an exact Science! Link to comment Share on other sites More sharing options...
Recommended Posts