HJG classic liners key

[liner simpilot]

It's been awhile since flying HJG liners, cannot remember the B-727- 100,200 rear airstairs key. Please I hope someone can help me out. 

Thanks simmers

[JSMR]

Not sure of the key, but it had an icon on the 'dashboard'. 

[graemeb]

I think the best way is to check out HJG support forums, where all the aircraft options are explained:

https://tonymadgehjg.proboards.com/board/2/boeing-support-forum

 

[aerofoto]

"JSMR" is correct .... there's an icom (located among the bank of panel icons .... only if one's using the HJG/PROBST B727 panels) which activates the ventral airstaires anuimation og all HJG supplied B727 3D models

"GRAEMEB" is correct also .... all details relating to the animations within these 3D models is presented within the following-linked forum based B727 manual (SECTION 1:07) ....

https://tonymadgehjg.proboards.com/thread/7819/b727-panels-installation-handling-notes

.... or as related below ....

[quote]All Door 1 forward fuselage exit folding air stairs, rear fuselage ventral air stairs, and port side forward fuselage main deck cargo door animations (B727-200 SCD subjects only), are controlled per "TAILHOOK, CONCORDE VISOR (EXTEND/RETRACT)", and "WINGFOLD" keyboard commands. These keyboard commands must be "manually assigned" within FS OPTIONS/CONTROLS/ASSIGNMENTS.

- SHIFT + E (open/close Door 1L)
- SHIFT + "CONCORDE VISOR FULLY EXTEND"/F6 (extend folding air stairs)
- SHIFT + "CONCORDE VISOR FULLY RETRACT"/F7 (retract folding air stairs)
- SHIFT + "WINGFOLD" commands (open/close ventral air stairs)
- SHIFT + "TAILHOOK" commands (open/close port side forward fuselage main deck cargo door on all B727-200 freighter/SCD model subjects only .... and starboard side lower forward fuselage cargo hatch on all B727-100 model subjects)

Failure to correctly assign these keyboard commands will result in these animations not functioning.

PLEASE NOTE: The "CONCORDE VISOR FULLY EXTEND/RETRACT" keyboard commands (to animate the folding air stairs at Door 1L) are based on "FS2004 assignments. This animation "cannot" work in FSX. The CONCORDE VISOR commands in FSX are based on a different combination of keyboard assignments .... which "are not" compatible with any of these B727-100/-200 3D models.

PLEASE NOTE ALSO: All HJG supplied PAX version 3D B727-100 V1.0 models feature opening/animated ventral/rear fuselage air stairs and Door 1L forward fuselage exits but no folding air stairs animations (this is how these models were supplied to HJG).

PLEASE NOTE ADDITIONALLY: All HJG supplied freighter/SCD version 3D B727-100 V1.0 models feature opening/animated ventral/rear fuselage air stairs and Door 1L forward fuselage exits but no folding air stairs or port side forward fuselage main deck cargo door animations (again this is how these models were supplied to HJG).[/quote]

In regard to technical support "for HJG simulations only". Always best to log onto the HJG forum for this .... and where all the related resources are located and more easily accessed by those requiring assistance in as much as those providing it also :)

Not easy (sometimes) to provide support on 2, or more/other FS forums .... as queries are often missed. "Just happen to" chance upon this query here today

MRC