logitech x56 stick, double throttle ,reudder pedals

[cchaserr]

This the x56 combination I am unable to set up the throttles as the setup always wants to work with the stick y axis which is assigned to the stick elevators. I cannot come up with any commands that work. The computer is new and high end. Fsuipc 7.+ is installed but is greek to me as how this works. I like the quality of these controls but this is the major function I wanted. Any and all comments for a work around would be appreciated.

[tiger1962]

Hopefully this thread on the flightsimulator.com forums will have the answer for you:

https://forums.flightsimulator.com/t/logitech-x56-throttle/305705

[cchaserr]

In first post I had only L y z axis to work with and after doing the regit process I now have R x y z axis. But the throttle #1 control will do nothing in a test .I assign the the l y axis and then the r y axis to throttle and the throttle levers do not test out. When I first got this I did have the throttles working on the L y command and they tested out but there was a double assignment with the stick elevators and I needed the extra R axis which I now have but they bind and don't work. Is their a way to test the throttle functions to ascertain they are actually doing something. I have only bound ailerons, ruudders ,elevators and brakes so there is no conflict with other functions. Or this module is not working!!!!

[tiger1962]

See posts #12 and #13 in this thread on the flightsimulator.com forums: https://forums.flightsimulator.com/t/logitech-saitek-x56-key-mapping-recommendations/282639/9

[cchaserr]

The throttles levers are the only connections that do no show correct in the Logitech x56 hotas test, nothing shows for them at all. All other function show correct. Can this be rectified or is it defective. Edited February 5, 2021 by cchaserr
word spelled wrong

[tiger1962]

Contact Logitech customer services.

[cchaserr]

This the x56 combination I am unable to set up the throttles as the setup always wants to work with the stick y axis which is assigned to the stick elevators. I cannot come up with any commands that work. The computer is new and high end. Fsuipc 7.+ is installed but is greek to me as how this works. I like the quality of these controls but this is the major function I wanted. Any and all comments for a work around would be appreciated.

 

Finally went through all instruction meticulously and there was no gradient profile assigned to throttles ,one second later nothing but joy