Jump to content

MS Force Feedback 2 joystick not working after upgrade from p3d v4 to v5

Recommended Posts

I've searched for a solution to this problem and I've seen where some in the past have had the same problem with FSX, but could not find a fix. The force feedback is on and works until you launch P3D v5, then the joystick just goes limp and the stick does not return to the center. I've checked and unchecked all of the boxes in the options, still the same, as well as trying the calibrations. I think it is flight surfaces I checked on as well as forceback and the plane was unflyable as the joystick forces were all over the place. Any ideas? Thank you

Jack T.

MSI Z370 SLI Plus, i7-9700k, 5.2GHz overclocked, 32 Gb DDR4 3600 MHz memory, EVGA RTX 2060 Super

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...