Jump to content

Zoom stuck at .40

Recommended Posts

as I cycle through the views, they are stuck at .4 when they are normally .6. Even if I adjust them, they just zoom back out again as I cycle through. How can I fix this?


I presume you are adjusting the zoom by just pressing the =/- keys. To make your chosen zoom persist for an EZCA view you need to edit the view.


For the view you want to change, press the key to enter 'edit' mode (you will get the ding-ding-ding noise), then change the zoom with your mouse wheel, then exit the edit mode. You have now changed the zoom permanently for that view. Repeat for the other views you want to change.




Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...