Ike Kant Posted February 12, 2016 Share Posted February 12, 2016 After installing and setting up a new CH Pro Yoke to replace my old one which only had a throttle slider (did not have prop or mixture control) my slewing function got weird. Now whenever I hit 'Y" on the keyboard to move the plane around on the ground, the plane immediately begins to spin quickly ccw. If I hit "5" on the keyboard or move either rudder pedal the spinning abruptly stops and I can proceed with normal slewing. This is after calibrating the yoke and pedals and no control surfaces are deflected. The rudder trim is centered. When I disable the joysticks all is well. What the heck? Too much of a good thing can be wonderful. - Mae West Link to comment Share on other sites More sharing options...
rthrosby Posted February 12, 2016 Share Posted February 12, 2016 Hit Ctrl = K before Y, the problem is with your stick/yoke. De-activates it. When you have finished slewing hit Ctrl = K again to re-activate your stick/yoke. Remember to keep the sky up and the land/water down. Link to comment Share on other sites More sharing options...
Ike Kant Posted February 13, 2016 Author Share Posted February 13, 2016 That's an acceptable workaround but there should be a way to fix it so that slewing works like it used to. Too much of a good thing can be wonderful. - Mae West Link to comment Share on other sites More sharing options...
il88pp Posted February 13, 2016 Share Posted February 13, 2016 if the plane spins in slew the rudder is not centred. (rudder deflection causes spin) [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
krobert Posted February 13, 2016 Share Posted February 13, 2016 Just look under settings / assignments... click on slew mode first, then select the yoke. Delete the unnecessary assignment that is causing it to spin and all will be good. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.