Jump to content

FSX Issue after Windows 10 Upgrade


Recommended Posts

I'm hoping someone here can shed some light on my issues so I can get them resolved.


I have been running FSX on Windows 7 for several years without issue. I have several add-ons that I have had for a while, and everything ran great. I have 3 USB cards I purchased from DesktopAviator to install and program switches. I have Saitek yoke, throttle quads, rudder peddles, AP and Radio panels as well. Everything was good up until a few days ago. I upgraded to windows 10. Downhill from there.


After upgrading, my computer got very glitchy. My screen would freeze. My switches would operate a different function that it was programmed for. And in some cases, FSX would just quit and close itself out. My computer finally started doing random reboots in the middle of a flight. Yesterday, I downgraded back to Windows 7. Fixed most all of my issues except for my switches. For example, I have a switch programmed for Generator 1. When I flip it, it might turn my Avionics off, or activate a starter switch. Doesn't do it every time, but enough to be aggravating.


Any help or suggestions would be greatly appreciated.

E8400 @ 3.6GHz, Zalman CNPS9500, Asus P5N-D w/ nvidia 750i SLI, Corsair XMS2 4GB 800MHz, WD 500GB X 2 SATA HDD, LG DVD-RW SATA, EVGA GTX 275 1792MB, Windows 7 Home Premium 64 bit, Dual Dell 24" ST2410 Monitors, Thermaltake Shark, Rosewill 750W Modular PSU
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...