HoratioWondersocks Posted November 26, 2015 Author Share Posted November 26, 2015 The correct answer is 0.316. Does that help any? Pat☺ Hello Pat I hope so . Its to do with the Beans possible solution to my startup question(obsession) for the beech 18. But this is positively my last effort. Flying it again as I write this message. Maths not my strong point. Cheers Andy Link to comment Share on other sites More sharing options...
PhantomTweak Posted November 26, 2015 Share Posted November 26, 2015 I kinda guessed as much, and math and I get along famously :D I love it. It explains the Universe, larest to smallest, everything is all math, if you look deep enough. Anyway... I looked at a lot of add-on as well as default aircraft, including several by Mr. Shupe. It looks like the general consensus is about 0.35 or there-abouts, so 0.316 may be a hair low, but that's the "usual" setting I could find. Hope that helps out a litttle bit :D Pat☺ [sIGPIC][/sIGPIC] Had a thought...then there was the smell of something burning, and sparks, and then a big fire, and then the lights went out! I guess I better not do that again! Sgt, USMC, 10 years proud service, Inactive reserve now :D Link to comment Share on other sites More sharing options...
MBKHOU Posted November 27, 2015 Share Posted November 27, 2015 Hello Pat I hope so . Its to do with the Beans possible solution to my startup question(obsession) for the beech 18. But this is positively my last effort. Flying it again as I write this message. Maths not my strong point. Cheers Andy I did that on mine, and it did start on both engines. But I used .328 I think.. I doubt it's too critical. Link to comment Share on other sites More sharing options...
HoratioWondersocks Posted November 27, 2015 Author Share Posted November 27, 2015 FS9 planes often need an aircraft.cfg tweak to start in FSX. In the [piston_engine] section, try increasing the... normalized_starter_torque=n.nn ...value, I usually double it.y peace, the Bean Thank you Bean! Your tweak worked! I started the Beech in manual, I will try the same with default Maule which also is only Ctrl e. Excellent thank you. Cheers Andy. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.