redbird 1 Posted December 23, 2016 Share Posted December 23, 2016 Recently installed FSX and hooked up my yoke and throttle Quadrant which I had used very sucessfully on my windows XP program. Now I have windows 10 and the yoke was recognized and works but the throttle quadrant does not. I did reinstall the drivers not knowing that windows more than likely would have recognized my yoke and throttle system. I suspect a conflict but not sure. Now at least I have the yoke but sure would like the use of the quadrant. I do have FSUIPC4 but not registered. I'm not a computer guru but with help I can find my way around. Any help would be appreciated. Merry Christmas to all who read this post. Link to comment Share on other sites More sharing options...
tjrush Posted December 23, 2016 Share Posted December 23, 2016 I seem to remember that when I installed my Yoke the axes weren't set. Go to FSX settings/controls and click the control axes tab. Make sure you have the following settings: aileron axis -- x axis elevator axis -- y axis mixture axis -- y rotation propeller axis -- x rotation throtle axis -- z axis ________ http://corporateairamerica.com/caaemailsig.jpg Link to comment Share on other sites More sharing options...
redbird 1 Posted December 23, 2016 Author Share Posted December 23, 2016 thanks tjrush. My settings are correct. power to throttle unit is on because I have the green light. It just won't respond. Neither the levers or the buttons. maybe the unit is defective. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.