Grover2005 Posted December 29, 2021 Share Posted December 29, 2021 Hi: I am using P3d Ver 5.3....When I activate "Slew" the screen goes into Warp 5 and I end up miles away from where I started before I can even tap the key to stop...Any suggestions on how to correct this? Thanks! Steve in Kansas 7 Miles NW of KGCK Link to comment Share on other sites More sharing options...
Clutch Cargo Posted December 30, 2021 Share Posted December 30, 2021 If you have FS hardware (or maybe even not), select slew mode in controls an make sure you have no axis assigned to slewing, then you can re-assign what controls you do want to use to slew around with. Link to comment Share on other sites More sharing options...
jagabom Posted November 12, 2022 Share Posted November 12, 2022 I had the same thing but it was a virus. Loaded a previous backup and all was well. Jim CYWG Link to comment Share on other sites More sharing options...
Recommended Posts