tatest Posted September 17, 2021 Share Posted September 17, 2021 I have about 150 hours now in FSX, about a third of this flying in contact with ATC, either IFR or VFR with flight following. I have AI traffic turned on for GA and airlines at moderate levels. Tags are turned on, and I see some AI traffic, enroute and around busy airports. However, ATC calls out a lot of traffic I simply cannot find. Is there more I need to do to make the traffic visible? Or does ATC in FSX call out phantom traffic in addition to what the traffic algorithms actually put out there to see. I don’t remember this in FS9. If ATC warned of traffic, it was visible. Link to comment Share on other sites More sharing options...
ac103010 Posted September 18, 2021 Share Posted September 18, 2021 Not sure this is the answer you're looking for but in your flight plans for AI aircraft the first part of the plan is: AC#1005,LE-XXX,10%,24HR,IFR The % there needs to be lower than your slider settings in your sim. I tend to keep my slider set at around 90% and the flight plan settings around 10%. Of course, you may be using packaged AI, like WoAI, so you'd have to decompile them to change any flight plans then recompile them again. Why not just set your slider to 90-100% to see if this works for you, first? Allan Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now