mickbass Posted February 9, 2021 Share Posted February 9, 2021 I am trying to build my cockpit, I am using Arduino Mega, Mobiflight and x-plane 11. I have connected 7 segment displays and they work OK, when I adjust in X plane it alters my display. The problem I'm having is the inputs, I can't get the Encoder to work or any switches. I have tried different Arduino's different switches and leads. Can anyone help please. Mick Link to comment Share on other sites More sharing options...
rfresh737 Posted September 29, 2021 Share Posted September 29, 2021 Did you post to the Mobiflight community? I was using SimVim which is similar to Mobiflight. Pretty easy to use, etc. but if their software doesn't support something, you're stuck. Also, your entire flight sim is dependant on them being around. If they go belly up, it's good bye also to your project. For those reasons, I stopped using SimVim and wrote my own code using Python and a Raspberry Pi 4 box. Of course you can still use your Mega and then write your own c code. RalphF http://www.gmtpilots.com Link to comment Share on other sites More sharing options...
Recommended Posts