Buzzer Posted May 4, 2020 Share Posted May 4, 2020 As part of my therapy while hiding from this COVID-19 situation, I have been building a 2D cockpit for the Flight Replicas DC4. I have it almost finished but have a problem with the view forward from inside the aircraft in MAIN_PANEL view. When the aircraft loads, the view of the outside through the windscreen only covers about 40% from the top (452 pixels on a 1920x1080 monitor). I can drag the lower edge to the bottom of the screen and all is fine, until I swap to another screen and return to the main, whereby the view is once again reduced to 40%. All other screens are OK and show a full view of the outside (excluding that portion that is obstructed by the aircraft framing). No other aircraft does this and they are all OK. I have checked the [VIEWS] and [Window00] sections and compared to other aircraft but cannot find any explanation. I have searched the internet for some clue but can only find information about setting up views etc. If anyone can point me in the right direction I would really appreciate it. Link to comment Share on other sites More sharing options...
andiroto Posted May 6, 2020 Share Posted May 6, 2020 Hello, Could be the entries under [Default View] in the panel.cfg, mostly the last lines at the bottom! Try to change the SIZE X Y values! Link to comment Share on other sites More sharing options...
Buzzer Posted May 7, 2020 Author Share Posted May 7, 2020 Thank you, I found the problem. I must have accidentally moved the vertical slider on FS Panel Studio. It was only occurring on one panel but took a while to locate the problem. Link to comment Share on other sites More sharing options...
Recommended Posts