Help with controlling Just Flight's PA-28R Arrow III

I have a Thrusmaster Warthog stick and throttle. This works very well with all AC in FS20. With the exception of Just Flight's PA-28R Arrow III and the Vacuum gauge version of the Cessna 172…I know, this is strange.

 

The Arrow has no trim control and the pitch/roll is not right. It may feel like the autopilot is on. I have done all I can to assure that the AP is off.

Now to add to this, if I put my old CH products yoke back on ALL runs fine.

I did write to JustFlight support and they had no answer.

 

Has anyone had this issue and found a resolve.

I had just the opposite. The CH yoke/pedals created roll/pitch issues even after i configured them and all that other stuff.

 

I finally just bought a Honeycomb Alpha and logitech rudder pedals.

 

 

Good luck!!

I'm very certain you've already done this, but I have to ask... did you calibrate your Warthog in the Windows peripheral window?

I'm very certain you've already done this, but I have to ask... did you calibrate your Warthog in the Windows peripheral window?

 

Thanks for the response.

 

Yes I did. But I should try again.

It is strange that it will work just fine with all other AC, and occasionally will perform OK for a couple of flights.

 

Is there anyone who flies the JustFlight Arrow with a Warthog?