How do I set up a aircraft to always open the same way

I have a 2 monitor system, one for scenery and the other for the G1000 and GPS displays. I know that I can open each window, undock is, move it to monitor 2 and lock them. When I save the sernerio the panels open but there are in the monitor 1 in the upper left

 

what I am after is when the aircraft is selected the panels go into the correct location. I know how to edit the air.config file but not sure if that is the correct spot or the fxml file that is save for the sernerio any ideas

My idea would be to get the situation that you want exactly on your screen then go up to the menu and select Scenario and save the flight. Then when you want that plane again just select Load and that flight should appear and then you can go from there with that anywhere in the world...Perhaps there are other ways as well but my setup is not as complex as yours

That is what I tried. It opens the panels ok but they are on monitor 1 so I need to drag them down to monitor 2. At least it opens them.

I use Display Fusion to setup my 2 screens and that works just fine.

You can use the 'free' version of the soft, that should do the trick.

FS9 toolbox by Eric Marciano will automatically place your panels on any monitor and exactly where you placed them. http://emarciano.free.fr/En/fs9Toolbox2.htm .. I use it to set up my panels. Jim..