acepdr

This what I love about this community, there is always somebody out there that can offer sound advice to work out the problems. 1) Yes the Bings Maps got turned off and of course the photogrammetry was off. I fixed that. 2) When looking around I selected the Eastern Tour and that's when I was presented with that I needed the World Update II: USA from the Marketplace. I downloaded and NOW I see the points of interest on the World Map. Thanks a bunch Guys, it's like If you decided to go for a walk in the Woods, you always take a Deck of Cards with you. " If you become lost, first sit down, pull out your deck of cards and start playing Solitare, and in short order, somebody will show up behind you and tell you to place that Red Seven over the Black Eight." All good now PDR

My System has not changed a whole lot, still running the following Ryzen 7 - 3700 CPU ASUS RTX 2060 Super Graphics Card. The latest USA update has included new areas to look over, for example the Airplane Graveyard in Tucson AZ, I cannot see any of this, nor can I see the other points of interest. Even my MAP selection on the front screen does not show the new points of interest. I looked over some history screenshots and I came across one I took of the Las Vegas strip from a month ago. The latest look does not even compare, lots of missing textures and buildings. I must confess, I did upgrade a new Monitor around the same time as the World USA Update, its as 32 Inch BenQ 4K monitor, which I have set to run in 2K settings within MSFS2020. I Keep adjusting Graphics settings trying to get into that HAPPY PLACE, but still not luck. I have the newest drivers from Nvidia and even did a optimize settings with them, not a whole lot of change from what I had set in MSFS. Any pointers out there on what I should try, or do you need more info on my settings to make a qualified judgement. Thanks PDR

Yes, I have a Saitek X52 Pro and I had earlier mapped a Prop Axis and Mixture Axis. After your suggestion, I removed both of these axis mappings and I testing so far has given positive results. I was able to fly 2 jest, Turboprop and Single Engine without them shutting down after a few minutes. Will continue doing more testing. Thanks for the big hint on where to look. PDR

I developed a issue in the last 24 hours, where all aircraft start properly but after a few minutes engines shutdown. This is across the board on all aircraft (Jet, Turboprop, Twins, Singles etc). I have not installed anything for the past few weeks which includes any engine mods. I checked all the settings to make sure something did not get turned off. The only major change was installing a new 32 inch Monitor. After painstaking trial and errors, I decided to do a clean install (again) of MSFS2020 which took over 12 hours. I just rebooted it up again and the SAME ISSUE IS HAPPENING. Any ideas out there PDR