Thank you for your reply, I am aware of what you say. Incidentally, I mistakenly laid out the set up wrongly. The correct order is: speed brake, engine 1, engine 2, flaps, spare, and landing gear. This is the layout of the 737-800 that I am training on. I can switch from one quadrant to the other in the settings page, but the sim sees them as one unit. For example: in my post, I pointed out that the right hand lever of the left quadrant was assigned to engine 2, and the right hand lever of the right quadrant was assigned to landing gear. However, a warning message states that multiple axis are assigned to the right hand lever. It does not distinguish between the left and right quadrants. No amount of switching between the quadrants and moving levers will change that fact. I am sure there must be a way to rectify this, maybe changing a line of code perhaps. How did you set up yours to overcome this?