Results 1 to 3 of 3

Thread: Course selection with FSUIPC installed does not work.

  1. #1

    Default Course selection with FSUIPC installed does not work.

    Cannot adjust course selection with FSUIPC active with the Dreamfleet 737/FFX merge. Works fine on all other aircraft.

    With FSUIPC disabled or removed from the modules folder, as per the instructions, adjustment is possible in 10 degree increments.

    I understand that this is normal operation with an unregistered version, but mine is registered.

    With FS9 up and running, my Modules>FSUIPC>About window reads "Version FSUIPC Version 3.125 18th November 2003 This is a Registered copy! Thank you!" on the left side of the window. The right side reads: "Registration This FSUIPC is registered to Roger Hodges [email protected]"

    I have tried various older versions of FSUIPC with the same results.

    I have also searched my system for an installation of an older version lurking somewhere and have found nothing so far.

    One more item. AutoPilot heading adjustments result in very sluggish response. I can manually increase my bank angle with the yoke and she rolls out on the selected heading normally. She just seems to need a little help in establishing a bank angle above about 10 degrees (Bank angle selection on the panel does not have any effect). In FMC modes, control seems to be normal and response is decisive. (FFX merge only)

    Both Peter McLeland and Peter Dowson have been contactd, but I though possibly someone else on this forum had run into this.

    Any ideas?
    RTH

  2. #2
    Join Date
    Mar 2005
    Location
    Brisbane, Queensland, Australia.
    Posts
    975

    Default RE: Course selection with FSUIPC installed does not work.

    check "fix control acceleration" in the technical tab in fsuipc

    Jeff

  3. #3

    Default RE: Course selection with FSUIPC installed does not work.

    Reinstalled Peter McLeland's panel.cfg file and all problems went away.

    Thanks for the help.
    RTH

Similar Threads

  1. Work work work work work...
    By Arabian in forum MSFS Screen Shot Forum
    Replies: 12
    Last Post: 01-11-2005, 01:53 PM
  2. Same Old Question: Course Selection does not work.
    By rhodges in forum DreamFleet General Discussion Forum
    Replies: 2
    Last Post: 08-12-2004, 10:07 AM
  3. Replies: 3
    Last Post: 08-12-2004, 08:27 AM
  4. COURSE APP does not work
    By bat2111 in forum DreamFleet General Discussion Forum
    Replies: 9
    Last Post: 02-07-2004, 12:24 PM
  5. 737-400 Course Selection Issue
    By adlion944 in forum DreamFleet General Discussion Forum
    Replies: 4
    Last Post: 05-06-2002, 01:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •