Jump to content

Software problems


mickbass

Recommended Posts

I am trying to build my cockpit, I am using Arduino Mega, Mobiflight and x-plane 11. I have connected 7 segment displays and they work OK, when I adjust in X plane it alters my display. The problem I'm having is the inputs, I can't get the Encoder to work or any switches. I have tried different Arduino's different switches and leads. Can anyone help please.

 

Mick

Link to comment
Share on other sites

  • 7 months later...

Did you post to the Mobiflight community?

 

I was using SimVim which is similar to Mobiflight. Pretty easy to use, etc. but if their software doesn't support something, you're stuck. Also, your entire flight sim is dependant on them being around. If they go belly up, it's good bye also to your project.

 

For those reasons, I stopped using SimVim and wrote my own code using Python and a Raspberry Pi 4 box. Of course you can still use your Mega and then write your own c code.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...