Flap Settings

I have a Throttletek !! I cannot get the flaps to go in increments just 0 to full how about you guys ??any suggestions

Make sure your assignment is to "Increase Flaps" and "Decrease Flaps" - which means you need to separate activators(Button, rocker, switch) DO NOT use "Continuous" or "Extend" or "Retract".

 

Increase and Decrease are incremental.

That where its assigned and it shall goes from 0 to full flaps

I am using my T5/6 toggle switch on my Logitech Pro Throttle Quadrant. I did notice that if I hold the switch down to long the flaps move 100% so I just tap it and release it and everything is fine. Hopes this helps

That where its assigned and it shall goes from 0 to full flaps

 

are they mapped to two separate buttons, a toggle (up/Down) switch or a rocker(left/right) ??

It's a flap lever like the real thing !! It's on a throttletek

very maddening it goes from 0 to full flaps

which throttletek model do you have? the GF14 or G737v2?

 

Can you take a screen shot of your flap assignment from your Control profile? please

which throttletek model do you have? the GF14 or G737v2?

 

Can you take a screen shot of your flap assignment from your Control profile? please

 

I have The Lear 45

it wont let me post a pic

Nice... a $1200 throttle that won't work. I can understand why your upset.

 

It looks like its an Axis controller. Assign it to flaps axis(0 to 100+)... check to make sure it works correctly - up should be zero...down 100...if not...click the reverse box.

 

Your flaps axis is not able to do increments, but you do have marks on your device that tells you how much flap your applying.

 

 

 

you should be good to go.

I have a Throttletek Lear 45 Throttle Quadrant and flaps work perfectly fine. Send me a private note with your email and I will see if I can help you get set up.

He has the settings for that input wrongly selected in Options.

Do you have to eliminate assignments on the keyboard for your throttle and flaps to work properly ????

Nice... a $1200 throttle that won't work. I can understand why your upset.

 

It looks like its an Axis controller. Assign it to flaps axis(0 to 100+)... check to make sure it works correctly - up should be zero...down 100...if not...click the reverse box.

 

Your flaps axis is not able to do increments, but you do have marks on your device that tells you how much flap your applying.

 

 

 

you should be good to go.

 

Maybe also check and play with the axis sensitivity settings?

Do you have to eliminate assignments on the keyboard for your throttle and flaps to work properly ????

No.