Cas141 Posted May 14, 2020 Share Posted May 14, 2020 Hello. I Am getting the hang of the airbus, but when on autopilot I go to dial in the frequency on Nav( for the glideslope activation) which is a two tier dial knob. The top part tunes the decimal points . That works ok. But the bottom tier will not accept the "mouse" for me to alter the digits for the whole numbers, I.e the three on the left of the decimal point. Is this a bug or is there something I am not doing right. Of course, until I can input the Nav frequency I cannot land in autopilot because I cannot obtain the glideslope! This is the Project A320 freeware Thanks Link to comment Share on other sites More sharing options...
mrzippy Posted May 14, 2020 Share Posted May 14, 2020 Does this A320 use the radio from the default A321? You might try comparing the [radios] section in the aircraft.cfg between the A320 and A321. Still thinking about a new flightsim only computer! Link to comment Share on other sites More sharing options...
Cas141 Posted May 14, 2020 Author Share Posted May 14, 2020 Not sure I have the A321. I take it you use the A321 and the dial works in that one? I'll have a look tomorrow Cheers Link to comment Share on other sites More sharing options...
Cas141 Posted May 15, 2020 Author Share Posted May 15, 2020 Have got round it. I use a second screen for fs commander and I have been able to go to 2d cockpit, bring up the radio stack and then move that window to the second screen. Therefore when I need to adjust the Nav frequency I can do so, still using the VC cockpit. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now