Page 4 of 4 FirstFirst ... 2 3 4
Results 31 to 35 of 35

Thread: Flightsim Navigation with NDB, VOR, DME, GPS

  1. #31

    Default

    28 Radios and Autopilot Project: Configure NAV1 MHz Encoder in Mobilflight

    We'll add an encoder in Mobiflight. The first step is to add it in the settings as a connected hardware element with the pin numbers it is wired to. Then in the 'Input' section we configure the encoder to control the events NAV1_FREQ_WHOLE_INC and -DEC.

    Link to the video.

    Link to the blog post.



  2. #32

    Default The panel is ready!

    The Radios & Autopilot panel is finished.

    More videos on Mobiflight configuration and on flying with it are in the making.




  3. #33

    Default

    29 Radios and Autopilot Project: Toggle Radio Tuning MHz / kHz in Mobilflight

    We can tune a NAV or COM radio MHz or kHz part with an encoder. This video shows how we can use the encoder's built in push button to toggle between MHz or kHz. For this we'll use an FSUIPC memory location where we store the number 0 or 1. We change the number when the button is pressed. We read out the number in the Precondition tab of the encoder MHz and the kHz functions to decide which of the two will be active.

    Link to the video.

    Link to the blog post.



  4. #34

    Default

    Radios and Autopilot Project First Flight: ILS landing

    After some 260 solder joints the panel is finshed. The video shows the first flight, an ILS landing, with tuning of the ADF and NAV1 radios and using the autopilot buttons and the Heading and Course knobs.

    Link to the video.

    Link to the blog post.



  5. #35

    Default

    Radios and Autopilot Project 30 Tune the ADF Radio in Mobiflight

    The ADF radio has three digits, for the hundreds, tens and ones. We're going to use the encoder push button to toggle between the three, after which encoder rotation will change the value. What I also did is add tuning of the ADF HDG card after a third press such that we can rotate the ADF card to our current heading and can read the bearing the neadle point to. This way we have full control of the ADF, first tune the frequency in three steps then tune the HDG.

    Link to the video.

    Link to the blog post.



Page 4 of 4 FirstFirst ... 2 3 4

Similar Threads

  1. VOR to VOR Navigation
    By Brodie in forum FS2004
    Replies: 10
    Last Post: 09-17-2008, 10:44 AM
  2. VOR/DME/NDB vs GPS vs FMC
    By xxmikexx in forum The Outer Marker
    Replies: 33
    Last Post: 05-02-2008, 01:10 PM
  3. Navigations question; DME, NDB
    By Rockcliffe in forum FS2002
    Replies: 17
    Last Post: 04-19-2003, 08:30 PM
  4. NDB but no DME
    By egnc in forum FS2002
    Replies: 1
    Last Post: 01-15-2003, 12:59 PM
  5. NDB with DME not VOR and not ILS
    By CCairns10 in forum FS2002
    Replies: 19
    Last Post: 06-17-2002, 06:45 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •