Jump to content

P3D + Beaver


gazman

Recommended Posts

Hello

 

I have the AS Beaver working with all gauges in P3D v4.5.

 

I have also installed a mod [to the panel.cfg] that replaces the existing DG [gauge07] with the Cessna C172 Heading Indicator. The Cessna gauge is visible only in the shift+1 and shift+2 views and not in the vc.

 

This was working fine until the new gauge suddenly became distorted - see pic. There is no loss of functionality.

2019-5-22_15-0-58-592.jpg

 

For clarification the gauge should display in the black hole behind it. It's like looking at it through a fish-eye lens.

I've reviewed all my settings and they are good.

 

Does anyone have a suggestion as to a remedy? Thanks.

 

Regards

gazman

Link to comment
Share on other sites

Gauge placement in the virtual cockpit isn't as simple as it used to be, at least for those aircraft which have "3D" panels, where some things are (if I understand correctly) built into the model. I've not messed with this myself, but have heard a few things, not enough to help you much.

 

Larry N.

As Skylab would say:

Remember: Aviation is NOT an exact Science!

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...