letting Posted May 24, 2018 Share Posted May 24, 2018 I can't get the mixture and prop levers to attain full 1% to 100% movement while using the yoke controls. Any assistance will be appreciated. JD Link to comment Share on other sites More sharing options...
stinger2k2 Posted May 25, 2018 Share Posted May 25, 2018 Check calibration and also chech the sensitivity settings would be my first port of call. Cheers Stinger Sent from my SM-G935F using Tapatalk Link to comment Share on other sites More sharing options...
letting Posted May 25, 2018 Author Share Posted May 25, 2018 Thanks, Stinger. Should sensitivity sliders be to the left or right? Dumb question, I know... JD Link to comment Share on other sites More sharing options...
stinger2k2 Posted May 25, 2018 Share Posted May 25, 2018 Full right, maximum sensitivity. ( off the top of my head). Cheers Stinger Sent from my SM-G935F using Tapatalk Link to comment Share on other sites More sharing options...
Rupert Posted May 26, 2018 Share Posted May 26, 2018 Full right, maximum sensitivity. ( off the top of my head). Cheers Stinger Sent from my SM-G935F using Tapatalk Correct! There is also a null zone setting. Make sure you turn it down to 0 until you find out what works for you. Personally I run about 65% sensitivity on everything but the rudder. To get that to work correctly with many aircraft I set it at 100% However some aircraft with larger rudders require the 65% setting I use for pretty much anything else. Being an old chopper guy I usually fly low and slow. Link to comment Share on other sites More sharing options...
Mark Hurst Posted May 26, 2018 Share Posted May 26, 2018 Should sensitivity sliders be to the left or right? First of all you need to decide if the Sensitivity slider is relevant to the problem you are having. Look in your fsx.cfg to see what this parameter is set to: [CONTROLS] STICK_SENSITIVITY_MODE=? If it is 1 or missing (1 is the default), the setting of the Sensitivity slider is not relevant. If it is 0, then you need to set your Sensitivity slider all the way to the right or change this parameter to 1. This is discussed in my . MarkH Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.