asos Posted September 18, 2017 Share Posted September 18, 2017 :confused:With Abacus FS Repaint, I am trying to paint a black antiglare panel on an a/c that has it mapped on the 3D model file, without success after many tries. Can anyone help me please? I can send the plane. If so, pm me sending me your normal email so I can send you the whole aircraft. Thanks in advance for any help you may give... Nick, Athens, Greece Link to comment Share on other sites More sharing options...
ColR1948 Posted September 18, 2017 Share Posted September 18, 2017 I use it, one piece of advice is 'Save' after every little thing then go back to do more if needed. It can crash or freeze up and if you have done a lot of work then all will be lost. When I first started using it, there were times I nearly threw the PC out the window because the program froze. I'll PM you my Email, hope I can help. Link to comment Share on other sites More sharing options...
Roger Wensley Posted September 18, 2017 Share Posted September 18, 2017 Nick, stop beating your head against that ai plane, it really doesn't matter! Link to comment Share on other sites More sharing options...
asos Posted September 18, 2017 Author Share Posted September 18, 2017 ColR1948, Please pm me your email. Roger, You have a point, of course, but I do want to get to the bottom of this, even if it means help from someone else. Thanks. Link to comment Share on other sites More sharing options...
ColR1948 Posted September 18, 2017 Share Posted September 18, 2017 I did PM you when this thread was in the other section. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.