Roger Wensley Posted September 13, 2017 Share Posted September 13, 2017 At a new CYRC airfield in the making (in Canada, where else?) I am ok with cockpit view, virtual cockpit view, and spot view. Why is the tower view actually "top down" and not from the tower? I use Scenery GenX for scenery making and the tower view is correctly entered in both position and elevation. This is confirmed when I open CYRC in AFCAD as a check that I entered it correctly. Ideas? Or I just write this off as yet another FS gremlin? Link to comment Share on other sites More sharing options...
Roger Wensley Posted September 14, 2017 Author Share Posted September 14, 2017 It works. I have no idea why. Link to comment Share on other sites More sharing options...
tgibson_new Posted September 14, 2017 Share Posted September 14, 2017 If you were loading the airport from a saved Flight perhaps the tower viewpoint is saved there? Tom Gibson CalClassic Propliner Page: http://www.calclassic.com Link to comment Share on other sites More sharing options...
Roger Wensley Posted September 16, 2017 Author Share Posted September 16, 2017 No Tom, it was the same situation each time; it just decided to work after having thrown a tantrum for a while. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.