wpann Posted April 21, 2017 Share Posted April 21, 2017 Hello Fellow Simmers, When I am using the numpad to lock in on a view outside my aircraft, I am only able to lock in on single number views (not 2 number views). For example, if I press 5 and 2 at the same time, the camera will not lock on that angled view. It will show me the angled view as long as I keep holding the 5 and 2 buttons, but it always locked in the view on my old system. The only way I can lock it is while holding the view, hit the S key to cycle back into the cockpit view and then back out to the outside view - but it should not have to work that way. Any help is always appreciated :) Link to comment Share on other sites More sharing options...
narksejaja Posted April 21, 2017 Share Posted April 21, 2017 I face the same problem and the only way to overcome it is to turn off the numbers pad, I hope there is a better solution. the other related problems is that some times the 4,6 buttons which should show the AC from the left and right, would show it from a 45 degrees from behind not really left or right. any solutions? Link to comment Share on other sites More sharing options...
wpann Posted April 25, 2017 Author Share Posted April 25, 2017 It appears as this issue only applies if you have a wireless keyboard. When I plugged in my old wired keyboard, the problem did not exist. Any thoughts? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.