Charlie Procter Posted August 27, 2015 Share Posted August 27, 2015 Hi everyone, I haven't seen a post about this so I'll ask myself. I just bought the saitek throttle quadrant to go with my yoke and I plugged into the yoke, the green light comes on all seems fine. I've programmed the 6 bottom buttons to my liking, and I've set the throttle, prop and mixture levers to the z, y and x axis but my problem is that rather than being a smooth movement on the sim when I move any lever up and down, I just get two setting- Idle and full. I was wondering how to set it so that the sim corresponds with the movement on my quadrant. I hope that's an understandable description. Thanks Link to comment Share on other sites More sharing options...
evm Posted August 30, 2015 Share Posted August 30, 2015 These need calibration I think. Thing to watch out for: the Saitek TQ has a small detent at its downmost setting, which is basically a button, not an axis. When you calibrate the levers, you should not enter this detent, minimum/idle setting is at the "0" position above the red stripes. Link to comment Share on other sites More sharing options...
Charlie Procter Posted August 30, 2015 Author Share Posted August 30, 2015 Ah okay I'll watch out for that, thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.