Help with P3D setting

Hi,

I use P3D and I want to get the best performance and graphics.

My spec is:

I5 3.8ghz

GTX 970

8GB RAM

 

What i have to do? Someone can help me with P3D.Cfg config? What I need to add?

And someone can help me with Nvidia inspector best setting?

 

What I have to do to get best performance and graphics?

Thank You

Install P3D2.5

 

Tweak NOTHING.

 

If you don't know what you are doing, you can only stuff it up. 2.5 comes ready-tweaked and most of the tweaks you will read about are nothing more than snake oil. The handful that do work deal with specialised and local issues which you won't know you have until you start with a default setup.

 

If you have specific problems, come here and ask specific questions and receive specific advice.

 

As for Nvidia Inspector, I'm sure there are a thousand snake oil salesmen who can cure whatever ails you.

Your cpu clock is marginal - if you can get above 4.0ghz you are much better off.

 

Initially - tweak NOTHING - especially if you are used to FSX - most of those tweaks either do not apply or will make things worse.

 

Depending on how you fly, what you fly, etc - you can start adjusting the normal sliders and get it the best for your system.

 

Vic

Install P3D2.5

 

Tweak NOTHING.

 

If you don't know what you are doing, you can only stuff it up. 2.5 comes ready-tweaked and most of the tweaks you will read about are nothing more than snake oil. The handful that do work deal with specialised and local issues which you won't know you have until you start with a default setup.

 

If you have specific problems, come here and ask specific questions and receive specific advice.

 

As for Nvidia Inspector, I'm sure there are a thousand snake oil salesmen who can cure whatever ails you.

 

I use P3D v2.5. Nothing do? No tweaking?

 

But I don't know what is the best settings for the simulator, you can help me may?

 

Your cpu clock is marginal - if you can get above 4.0ghz you are much better off.

 

Initially - tweak NOTHING - especially if you are used to FSX - most of those tweaks either do not apply or will make things worse.

 

Depending on how you fly, what you fly, etc - you can start adjusting the normal sliders and get it the best for your system.

 

Vic

I installed FTX global and vector and also FTX open lc to better graphics.

 

You can help me with settings?

Each of those addons has its own manual, with suggested settings for the sim.

 

Try them.

Accept the DEFAULT settings for P3D and whatever defaults that Global and Vector suggest

 

HOWEVER -

 

I strongly recommend that you do NOT install GLOBAL, Vector or openLC AT THIS TIME.

 

Get P3D set WITHOUT add ons and THEN install and adjust as necessary.

 

To go back to default settings in P3D you can just delete the prepar3d.cfg file located in:

 

C:\Users\(your name)\Appdata\Roaming\LockheedMartin\Prepar3dv2

 

Vic

I only have added to my config that which is suggested on facebook on the Prepar3d site and My Prepar3d works wonderful....just wish the level d 767 was on P3D and that the engine reversers and flaps would show with the PMDG on Instant Replay but they do not show on FSX either....but Quality Wings 757 does....My P3D is just fine with limited tweaking....al v