Jump to content

FSX Autopilot issue


TheCyberKiller

Recommended Posts

Hi, i have a problem with the altitude autopilot when flying vatsim or multiplayer, it works on single player but on vatsim/multiplayer when enables the aircraft dives to the ground, the v/s is set to 1800 for climbing but i just dosent work! i have tried everything. please help!! btw it is the same in any aircraft.
Link to comment
Share on other sites

Does this problem occur when you start the client that connects to VATSIM but do not connect? What happens when you are in the air and then connect or start the client?

 

It happens whenever on vatsim or multiplayer, once I've taken off and switch on the auto pilot it just dives to the ground, its anytime when connected. It works fine on single player!

Link to comment
Share on other sites

Check and see you have the (pitot_static) section (2 lines) in your Aircraft cfg.

If not, ADD it and click SAVE.

 

[pitot_static]

vertical_speed_time_constant= 1 //Increase,,,,for more...reaction in the VSI

//(Then change the vstc from 1 to 99.9 )

pitot_heat = 1.0 //Scalar on heat effectiveness,

i7 2600K @ 3.4 Ghz (Turbo-Boost to 3.877 Ghz), Asus P8H67 Pro, Super Talent 8 Gb DDR3/1333 Dual Channel, XFX Radeon R7-360B 2Gb DDR5, Corsair 650 W PSU, Dell 23 in (2048x1152), Windows7 Pro 64 bit, MS Sidewinder Precision 2 Joy, Logitech K-360 wireless KB & Mouse, Targus PAUK10U USB Keypad for Throttle (F1 to F4)/Spoiler/Tailhook/Wing Fold/Pitch Trim/Parking Brake/Snap to 2D Panel/View Change. Installed on 250 Gb (D:). FS9 and FSX Acceleration (locked at 30 FPS).
Link to comment
Share on other sites

  • 2 weeks later...
Check and see you have the (pitot_static) section (2 lines) in your Aircraft cfg.

If not, ADD it and click SAVE.

 

[pitot_static]

vertical_speed_time_constant= 1 //Increase,,,,for more...reaction in the VSI

//(Then change the vstc from 1 to 99.9 )

pitot_heat = 1.0 //Scalar on heat effectiveness,

 

Thankyou, This must have been my problem. its all fixed now thanks again

:):)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...