When it comes to British Columbia and Utah God certainly worked overtimeStunning place and looking good in the shots Steve! have you came across any natural sculptures yet?
cheers
David
AMD Ryzen 9 3900X 3.79 GHz
ASRock B550 Phantom Gaming 4 Motherboard
4x8GB = 32GB DDR4 Vengeance LXP 2400MHz
XFX RX 5600 XT Thicc III ULTRA-14GBPS 6GB Boost UP to 1750MHz GDDR6 3xDP
Hello David,
Hmmm, no, I haven't seen any natural sculptures yet, however, I don't know if Gottfried has these as photoreal, or, 3D models, and to be very honest, I personally don't know the area very well at all and don't really know where to look, it is a big place!!! I did find a map, but, it goes into Colorado and Gottfried doesn't seem to have covered the whole of that state yet, just Mesa Verde National Park up to Durango.
I'll keep looking but there is such a lot to download and at 25 squares per plot for FSX, it's taking me ages to download just one area at a time, I'm likely to be installing content all next week at this rate......
Cheerz. Steve.
I reckon we will have it cracked by xmas. I'm in a power outage at the moment thank god for laptops. I can't fly as FS9 on external but i can still download!!
I will see what photos i can find of the stuff I mean.
OK this is the kind of stuff....
cheers
D avid
Last edited by daspinall; 07-02-2011 at 10:52 AM.
AMD Ryzen 9 3900X 3.79 GHz
ASRock B550 Phantom Gaming 4 Motherboard
4x8GB = 32GB DDR4 Vengeance LXP 2400MHz
XFX RX 5600 XT Thicc III ULTRA-14GBPS 6GB Boost UP to 1750MHz GDDR6 3xDP
Hmmm, not sure about Xmas, 2013 more like......
I found a few photographs on the internet as well, but, as I said before, it's where to find them within the scenery add-on is the major problem and if they haven't been included then there's no point in trying to find them, I'll e-mail Gottfried and see what he says.
Thanks anyway,
Cheerz. Steve.
Last edited by TransportSteve; 07-03-2011 at 06:02 AM. Reason: re-edit
Nice shots Steve, the scenery looks very good.
Utah--especially the desert areas--is pretty special. Other than mesas and such which are dig enough to show up with your mesh, I doubt you'll see any smaller formations. I'm trying to figure out a reasonable way to add arches, etc as objects for some scenery I'd like to release of the Canyonlands/Arches NP areas.
Rich
AMD Ryzen 9 3900X 3.79 GHz
ASRock B550 Phantom Gaming 4 Motherboard
4x8GB = 32GB DDR4 Vengeance LXP 2400MHz
XFX RX 5600 XT Thicc III ULTRA-14GBPS 6GB Boost UP to 1750MHz GDDR6 3xDP
I've had a reply from Gottfried who stated that he hasn't created any 3D models on this scenery add-on, so, it's photoreal only and if the structure is very small I doubt if you'd be able to identify it anyway unless you are extremely familiar with the area concerned.
Cheerz. Steve.
Truely amazing scenery!
It's the free bit that impresses me!
Nick
Bookmarks