chausler49

I purchased the H145 and P38L from their respective developers. I installed and like both platforms very much. Recently, both developers have provided updates to these aircraft that require me to de install the old and re install the new. I de installed but have not been able to reinstall. I follow the instructions to the letter without success and the developers are radio silent. I am stumped. Any aircraft I have purchased from the marketplace installs easily in the official file. Has anyone ever taken an unzipped aircraft file and dropped it into the official file vs the community file to attempt installation? I dont want to mush things up but it seems like it could work. Any advise would be appreciated. Thanks

No manual for F14, or the new DH6 Twin Otter. I am sure they are there but I cant locate. Again, these were purchased through the MSFS Marketplace

Yet another dumb question but here goes. I cannot seem to locate the flight manuals for any aircraft purchased in MSFS 2020 marketplace. I have the manuals for all others purchased via 3rd party. I am sure this is an easy fix but I haven't and cant seem to figure it out. Any info would be appreciated. Thanks in advance.

Many thanks Steve

Friends, Another issue with recent updates for me. I go into content manager to install the 2 updates, as soon as i do that, it shuts MSFS 2020 down and pushes me to my computer home page. When I logged in today, i got a notice that my MFSF 2020 license is not verified and directs me to the MS Store which yields no result. It will however allow me to fly the sim without installing updates. I am confused. Any assist or direction would be appreciated.

I recently purchased the Flyingiron P38 Lightning. I got it down loaded to community folder after a few issues. It fails to install. I can see it in my content manager when I open MSFS 2020 but no joy with installation. Any words of advice? Thanks in advance. Carl

Tim, well I tried your suggestions to the letter and still get the same error code message. Very frustrating to say the least. I appreciate your efforts. Carl

Wow!!! Thanks for the fast response Tim. I will attempt your fix! Carl

Tim, I have seen a couple of your responses to software related issues and I wonder if you might assist me with one I am having since installing 2020-6. I flew a short flight and my computer crashed. I went to restart and I got the message that I had possibly downloaded 3rd party software which i had not but prompted me to start in safe or normal mode. I have tried both modes and each sends me to a notification that I have an xbox error code (0x80004005) and I should try again later. The error code instructs me to reboot my xbox console which i dont have as I am running on a PC. I get no assistance from xbox or MS store. I have de and reinstalled both programs. If you can help I would be grateful and no worries if you cant. Best Carl

Dave, I guess the other problem is that I am not a tech guy. No idea how to update PC chip drivers. I do know that under controls in set up, the computer recognizes the X52 for default purposes. I did inspect the connections as you suggest and no joy. I am looking to purchase new but all of the vendors seem to be out of stock. Go figure. I thank you for your kind response. Carl

So i installed MSFS on a new computer as my old one had no where near the needed processing requirements. I plug in the Saitek X52 which worked very well on the old system, into the new. The left side works great with throttle etc but the right side blinks blue lights on all available LEDs. I have gone into mapping but the system will not allow changes. No Joy. To make matters worse, when I plug the controller back into the old computer, it works fine. Any ideas on resolution would be much appreciated. Thanks in advance.