Jump to content

cchaserr

Registered Users
  • Posts

    7
  • Joined

cchaserr's Achievements

Advanced  Simmer

Advanced Simmer (2/7)

  • First Post Rare
  • Conversation Starter Rare
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

10

Reputation

  1. This sim is almost impossible to hand fly. The inputs on the ailerons were slow to react, necessitating some over con controlling. Air speed with all throttles to idle show poor reaction. The dynamics of the sim need to to be adjusted to reality. The programmers have a lot of rework to do.
  2. Finally went through all instruction meticulously and there was no gradient profile assigned to throttles ,one second later nothing but joy
  3. The throttles levers are the only connections that do no show correct in the Logitech x56 hotas test, nothing shows for them at all. All other function show correct. Can this be rectified or is it defective.
  4. In first post I had only L y z axis to work with and after doing the regit process I now have R x y z axis. But the throttle #1 control will do nothing in a test .I assign the the l y axis and then the r y axis to throttle and the throttle levers do not test out. When I first got this I did have the throttles working on the L y command and they tested out but there was a double assignment with the stick elevators and I needed the extra R axis which I now have but they bind and don't work. Is their a way to test the throttle functions to ascertain they are actually doing something. I have only bound ailerons, ruudders ,elevators and brakes so there is no conflict with other functions. Or this module is not working!!!!
  5. n0w at wits end. The stik has x y and z x handles ailerons y handles elevators , the stick has a twist for the rudder but this is mapped to the rudders/brakes on the floor controls. I now need an y axis for the brakes, throttle 1 and 1 for throttle 2. When I try to assign all I get are the stick assignment menu. Where do I find assignments for the throttles and others. The switches on the throttle console are easy to program. I have used the FS since they started and never encountered this. help!
  6. This the x56 combination I am unable to set up the throttles as the setup always wants to work with the stick y axis which is assigned to the stick elevators. I cannot come up with any commands that work. The computer is new and high end. Fsuipc 7.+ is installed but is greek to me as how this works. I like the quality of these controls but this is the major function I wanted. Any and all comments for a work around would be appreciated.
  7. I have the msfs 10 pack loaded with fsuip 7 registered version stating when the fs is loaded. Have new hotas, rudders, throttles coming. I need info on what to do to install new flight gear when I have FS running. The next 6 to 8 steps would help greatly.
×
×
  • Create New...