Jump to content

trainee_pilot

Members
  • Posts

    1
  • Joined

trainee_pilot's Achievements

FlightSimmer

FlightSimmer (1/7)

  • Week One Done
  • One Month Later
  • One Year In
  • First Post Rare
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. Except for the pitch and roll calibrations, all other buttons are being recognized, including throttle quadrant. Only these 2 axes are not being recognized. I turned on the Data for the 2 axes on X-plane so that I can see what is being output when I fly the plane. Nada. No data is coming through. So I can't use the yoke. When I googled around for this issue, I noticed that others also have had this issue. But they were all old posts like 3 years old. And nobody had managed to resolve the issue. To double check, I downloaded the Flight Configuration software from Logitech's website. I loaded the X-plane config. Again here as well, all buttons I can configure except the 3 axes. I'm using Mode 1 on the Flight Yoke. I'm currently using a joystick but want to really transition to the Yoke. Any help would be much much appreciated. The yoke has been sitting unused forever. High time I found a solution. I'm on Windows 10, Xplane 11 Note : I tried it on a different PC with the same results.
×
×
  • Create New...