GranddadAviator

Thanks everyone for your replies! I'll see what it does tomorrow, since it was pointed out it isn't due to release until the 27th. It definitely is large as pointed out, it is nearly 80 GB.

Hello everyone, I noticed in MSFS' Marketplace there is a Core Content update. It says to re-launch the application, which I have done several times, but it doesn't appear to be installing. The option to check it for installation is disabled as well. Am I missing something? How do I get the update to install. Thank you for any assistance!

Thank you so much for your responses. It is greatly appreciated. As I suspected, I was doing something wrong. In the Controler assignments in MSFS 2020 I was setting Roll Left and Roll Right. Then looking at it again I saw there was Aileron Axis, I cleared the Roll Left and Roll Right settings and set the Aileron Axis and "boom" everything worked correctly. Yep, if at first I don't succeed... find my mistake. :) Thank you again, and safe flying!

I'm having the same issue also. I map the controls, but the flight controls (ailerons and elevator) do not work properly.

Hi Everyone, I have a new CH Products Flight Yoke, but it is the older model. I've had the same flight yoke in the past and it has worked fine, but it has been years since I've configured or used it. I map the controls in MSFS' Options -> Controller section but when I fly the controls respond terribly. I have to turn the yoke to extremes to get it to respond and then it responds dramatically. I cannot input subtle movements. I imagine the problem isn't the yoke or MSFS, but my lack of knowledge on how to set it up correctly. I'm not sure if I should be using Mapped or Direct mode. So far it doesn't make a difference which one I choose. MSFS mapping seems pretty straight forward, but again the flight controls do not respond properly. Does anyone have any suggestions on how I can get this to work properly? Do I need to create a .map file? Is there a place to download a preconfigured .map file for MSFS? How do I get MSFS to recognize the mapping? Is Direct Mode better? Yea, I'm pretty lost right now. Any help would be appreciated. Thank you in advance for any assistance.