• Indiafoxtecho Releases Long-EZ for MSFS

    Indiafoxtecho Long-EZ For MSFS Released

    It seems that the proper support for canard planes has not been included in the latest 1.9.5 update of Microsoft Flight Simulator as promised... therefore, since I have been waiting for almost one month now, I have decided to publish the Long-EZ as is and then update it whenever the canards are properly implemented by Microsoft.

    Note that the only appreciable difference is the stall behavior... while in most other flight conditions, the aircraft should behave in a realistic way.

    Purchase the Long-EZ Here
    Source
    Indiafoxtecho MB-339 Update
    Indiafoxtecho Now Official DCS Developer


    1 Comment
    1. tirith63's Avatar
      tirith63 -
      Flies very nicely Definitely keep some forward pressure on the stick, as recommended, on your take-off roll, until you're ready to rotate... Thanks very much! Nice job.
  • Recent Forum Activity

    HornetAircraft

    Level-D 767 New VC Textures

    Thread Starter: HornetAircraft

    hello all! So I got the Zinertek VC Upgrade, but to me the quality was atrocious. the textures just seemed blurry, like they were resized from a...

    Last Post By: tiger1962 Today, 11:11 AM Go to last post
    lillyluna23

    Specs

    Thread Starter: lillyluna23

    Hey, are these specs good to run fs9? Thanks Processor: intel core i5 2400 @ 3.10ghz Ram 8gb DDR3 1TB sata hard drive Graphics card: 2gb Nvidia...

    Last Post By: Skywatcher12 Today, 11:07 AM Go to last post
    K5083

    Well, that was fun but I'm back! (from FS2020)

    Thread Starter: K5083

    So I arranged to be gifted FS2020 (I refuse to call it MSFS, as some would like, as if there was never an MSFS before) for Xmas and, it being the New...

    Last Post By: JSMR Today, 10:45 AM Go to last post
    bohi

    Model for A321 and A330 and others

    Thread Starter: bohi

    Dear all, Where do I find models for the A321 and the A330. Kind regards Bo Hildebranner

    Last Post By: Apollo212 Today, 10:33 AM Go to last post