• Indiafoxtecho Releases Long-EZ for MSFS

    Indiafoxtecho Long-EZ For MSFS Released

    It seems that the proper support for canard planes has not been included in the latest 1.9.5 update of Microsoft Flight Simulator as promised... therefore, since I have been waiting for almost one month now, I have decided to publish the Long-EZ as is and then update it whenever the canards are properly implemented by Microsoft.

    Note that the only appreciable difference is the stall behavior... while in most other flight conditions, the aircraft should behave in a realistic way.

    Purchase the Long-EZ Here
    Source
    Indiafoxtecho MB-339 Update
    Indiafoxtecho Now Official DCS Developer


    1 Comment
    1. tirith63's Avatar
      tirith63 -
      Flies very nicely Definitely keep some forward pressure on the stick, as recommended, on your take-off roll, until you're ready to rotate... Thanks very much! Nice job.
  • Recent Forum Activity

    solomod

    Joystick sticky buttons

    Thread Starter: solomod

    I don't know whether this will be of interest or in the correct forum but here goes. I have used FS2004 for years and I have a Logitech Extreme3D...

    Last Post By: solomod Today, 04:32 AM Go to last post
    CTarana45

    Will Fs2004 work under 64bit OS's?

    Thread Starter: CTarana45

    My new computer is a Toshiba laptop with Windows 7 64 bit. Will Fs2004 run on that? :pilot: Christopher Tarana

    Last Post By: solomod Today, 04:17 AM Go to last post
    usb777

    Real Weather Engines

    Thread Starter: usb777

    I seldom fly my FS9 anymore I have FSX and MSFS but last night neither my Active Sky Evolution 0or my REX FS2004 Overdrive would inject the live...

    Last Post By: usb777 Today, 01:47 AM Go to last post
    plainsman

    New Where did you fly today

    Thread Starter: plainsman

    The original thread had lots of interest, but is getting too large. A short flight from Phillipsburg, Kansas to Holdrege, Nebraska. You fly over...

    Last Post By: inky160 Yesterday, 10:57 PM Go to last post