• DC Designs Concorde - The Legend Flies Again!

    DC Designs Concorde released for FSX/P3D

    DC Designs' all-new VR-ready model for P3D v1-v5 and FSX comes in four liveries and features a fully animated exterior model with custom-coded multi-stage 'nose droop' and windscreen animations, accurate flight model with Mach 2 'super-cruise' capability, crew-controlled GPU and full interior and exterior night lighting.

    Other features include 3D modelled dials throughout the cockpit, operational Captain's, First Officer's and Engineer's stations, accurate flight model with Mach 2 'supercruise' capability, working TCAS display, INS and fully modelled passenger cabin.

    The new P3D/FSX Concorde developed by DC Designs features a highly detailed 3D model based on extensive research and visits to museum-exhibit aircraft, with a fully animated exterior model including all access doors, engine inlet ramps, thrust-reverse buckets and control surfaces.

    Concorde's famous, multi-stage 'nose droop' and windscreen animations have been recreated via custom coding and features include PBR textures (P3D v4/v5 only), a crew-controlled Ground Power Unit and boarding steps, and full interior and exterior night lighting.

    Product Page
    Just Flight/DC Designs Concorde Update
    New DC Designs Concorde In Development For P3D/FSX


    1 Comment
    1. mgleisbe's Avatar
      mgleisbe -
      Hello,

      I bought this, & I have to say very disappointing all round not worth the money paid. Sorry Just flight & DC designs.
      Its doesn't live up to my expectations.

      MattG
  • Recent Forum Activity

    daspinall

    fs2020 VR recommendations....

    Thread Starter: daspinall

    Ok seen a few videos of pilots using VR headsets, I'm impressed with the visual quality.... I remember years back in the 2004 sim the VR sets where...

    Last Post By: daspinall Today, 06:27 AM Go to last post
    Sean C

    Almanac and Celestial Navigation Calculator

    Thread Starter: Sean C

    Hello All, I was advised by ET2SN over at subsim.com to contact Tom Gibson from "Cal Classics" about a spreadsheet I'm working on. It contains a...

    Last Post By: Sean C Today, 05:07 AM Go to last post
    rafalrafal

    Older plane, contact points, FSX

    Thread Starter: rafalrafal

    Hello everyone, This is an old topic discussed many times before, but this matter is not quite clear to me as I am very likely interpreting contact...

    Last Post By: napamule2 Today, 04:21 AM Go to last post
    ster100

    How to open, enlarge radio/nav panel?

    Thread Starter: ster100

    In xplane: dubbel klick. In FS2020?

    Last Post By: howlak Today, 04:10 AM Go to last post