• Taburet - Prepar3D V5 Switzerland and Austria 10 m Mesh

    Prepar3D V5 Switzerland and Austria 10 m Mesh

    10 m terrain mesh for the whole of Austria and Switzerland built from Lidar data and compiled with 10 m resolution elevation points. This mesh is very light on frame rates and it does blend seamlessly with default airports avoiding any terracing around airport areas. Give a new fresh look to the simulator terrain mesh, avoiding terrain distortions around airports perimeters caused by older dated mesh.

    Purchase Prepar3D V5 Switzerland and Austria 10 m Mesh

  • Recent Forum Activity


    Nothing But Trouble After May 25 Update!

    Thread Starter: Mac6737

    I had two months of CTD-free aviation bliss until May 25, and installation of the last putative "update." Now, I can't open anything in Alaska, and...

    Last Post By: tiger1962 Today, 03:06 PM Go to last post


    Thread Starter: Miahflyer

    Hi! Guys My current M2nve hard drive on which the MSFS2020 is installed is getting full I am wondering if I move the Addon Linker to a different hard...

    Last Post By: danbiosca Today, 01:32 PM Go to last post

    Ai Aircraft porpoising on landing.

    Thread Starter: ColR1948

    I used to have the correction for this but I seem to have lost it, I remember it was about 3 lines in the aircraft.cfg you had to alter and it cured...

    Last Post By: ColR1948 Today, 12:57 PM Go to last post

    Where did you fly today ?

    Thread Starter: stinger2k2

    Hi all, I thought that I would lighten the mood by throwing this one out there. For me, three flights today EGNH (Blackpool) to EGKK (Gatwick)...

    Last Post By: VFRguy Today, 12:17 PM Go to last post