Jump to content

help aircraft.cfg


Recommended Posts

It might be this or this


I'm not entirely sure. Try increasing drag, but that may effect it's flight characteristics. It's more than likely the engine settings.


Always remember to backup your current aircraft.cfg before you edit it.

Link to comment
Share on other sites

The engine on your lawnmower? Boat? Skidoo? Quad? Motorcycle? Jet? Turbo Prop? Piston? Hybrid? HAHA.

Chuck B


i7 2600K @ 3.4 Ghz (Turbo-Boost to 3.877 Ghz), Asus P8H67 Pro, Super Talent 8 Gb DDR3/1333 Dual Channel, XFX Radeon R7-360B 2Gb DDR5, Corsair 650 W PSU, Dell 23 in (2048x1152), Windows7 Pro 64 bit, MS Sidewinder Precision 2 Joy, Logitech K-360 wireless KB & Mouse, Targus PAUK10U USB Keypad for Throttle (F1 to F4)/Spoiler/Tailhook/Wing Fold/Pitch Trim/Parking Brake/Snap to 2D Panel/View Change. Installed on 250 Gb (D:). FS9 and FSX Acceleration (locked at 30 FPS).
Link to comment
Share on other sites

On the ground all turbine (turbo-prop) and jet engines need to build up compression pressure before they actually begin to produce the expected power as the result of increased throttle settings. It's called "spooling up", is perfectly normal and can take upto a few seconds.

Turbine engines are especially prone to it in the range between idle RPM and taxi RPM. It's sometimes even difficult to control turbo-prop taxi speeds accurately by using only the throttles, hence pilots setting their throttles a little higher than idle and then using their brakes to control taxi speeds.

Once in the air and at speed, this effect becomes less due to air being "rammed" into their engine's inlet manifolds.


Hope this helps


Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...