Making my FS2000 Lake Reneagade 270T able to land on water

[eagle013]

[font size="1" color="#FF0000"]LAST EDITED ON Jan-06-02 AT 01:03PM (EDT)[/font][p]The lake renegade 270T is a boat hulled single engine amphibious aircraft, much like the caravan. The problem is when I use FSedit to make it's hull/fusulage a float, it will change it back to a scrape point. same with the sponsons on each wing. How do I make my seaplane a seaplane? (I checked the tips library, but it was little or no help this time =(. )



-----------------------------------------------------------------------------


http://www.flightsim.com/dcforum/Use...8c6dabd9fb.jpg

[eagle013]

[font size="1" color="#FF0000"]LAST EDITED ON Jan-06-02 AT 02:11PM (EDT)[/font][p]Correction: the 270T is much like the caravan without the floats. It just has a hull. See my signature.



-----------------------------------------------------------------------------


http://www.flightsim.com/dcforum/Use...8c6dabd9fb.jpg

[bilbo]

Umm.... isn't reneg02.zip already setup with wheels/floats version?
At any rate, you can edit the arcraft.cfg file scrape points in notepad as well and make the #1[Wheels] into #4 [Floats].
Bilbo™

[eagle013]

Sorry, I didn't know there was a FS2002 Renegade yet, thanx =)



-----------------------------------------------------------------------------


http://www.flightsim.com/dcforum/Use...8c6dabd9fb.jpg