Elevator Trim Stuck in Up Position in FS 2004

**tcr1016** · 10-29-2005, 09:49 AM

When I launch any aircraft the elevator Trim is centered and immediately moves up and stays. I can not get it to budge. I tried reassigning the controls and nothing works. I used the keyboard and yoke, still nothing. I use the CH Products USB yoke and rudder.

Any help will be appreciated,

Todd

**jlongstreet** · 10-29-2005, 11:49 AM

Hey Todd,

Is your autopilot engaged with altitude hold turned on during takeoff? I used to do that and the result was the same as you described your problem.

Just a thought.

Regards,
Longstreet

**tcr1016** · 10-29-2005, 01:53 PM

Hey Longstreet,

It maybe. How do I turn it off?

Thanks Todd

***Paul Golding*** · 10-29-2005, 02:06 PM

Press Z and see if that allows you to adjust the trim.

**tcr1016** · 10-29-2005, 03:09 PM

It did not work. Any other ideas?

**FITZY** · 10-29-2005, 05:03 PM

I was thinking that, but the AP light in the screen shot is off. How about the trim wheel on the left side of the CH yoke body? Is it all the way up?

**tcr1016** · 10-29-2005, 05:06 PM

I moved it up and down and no luck.

**FITZY** · 10-29-2005, 05:17 PM

Do you have a stick you can swap out with the yoke? That would eliminate the yoke if the problem persist. Maybe even unplug the yoke and try flying from the keyboard.

**Kimber** · 10-29-2005, 05:17 PM

You may need to delete the FS9.cfg and reboot!!

**tcr1016** · 10-29-2005, 05:24 PM

I tried only the keyboard and no luck.

I contacted Microsuck (sorry soft) and they had no clue with me on the phone for 2 hours. I rebooted, uninstalled, even a little coochie hoochie dance and still no luck.