ATC clearances for TO & landing in different RWYs

[sandokan]

Hi to all,
In a previous post it was explained how by AFCAD2 it's possible to force ATC to use For TO and landing two different NON PARALLEL RWYs.
I wasn't able to understand the method.
There's somebody who knows this tip and can kindly step by step point me to understand how to make it.
I would like to have in Rio de Janeiro Galeao Int'l,setting a suitable wind,TO from RWY 10 and landings on RWY 15.
Thanks Sandokan

[ronzie]

The one afcad2 for SBGL I had found here in the libs was not the virtual crossrunway star model. I loaded it into FS9 so it would index and then looked at the runway list in AFCAD2. It did not show the long list of runways you get with the star method. Also while there were 61 parking spaces now airline parking assignments were made.

There should be a tutorial at projectai.com and maybe the airport has been done. If not look for a tutorial in the AFCAD forum over there especially any FAQ links.

Try making an AFCAD2 for a simple out of the way airport first adding one runway and setting its properties. When you have that successfully accomplished go on to making several at the same center point but with just a few degrees heading apart, about 6 degreesas I recall. Make them very short and close both ends to traffic for the fake ones.