AFCAD Scenery problem

[SD_BFU]

Hello simmers;

I have strange ptoblem with one scenery, I made in AFCAD: it's small airstrip on one Arctic island (Franz-Joseph Land), and it shouldn't pose any problems, however, after the airport was created - runway, taxiway and apron - they seem to move over the surface during fly-by. All elevations are accurate, I used AFCAD before and never had that effect.
Anybody?

10x a lot in advance.

[Dijon76]

Because of the way FS displays the earth if scenery is too far north or south it can cause this problem. I have seen something on this before just dont remember where.

[tgibson]

Hi,

Or your airport elevation may not match your AFCAD elevation. Either move the AFCAD elevation down to match the ground elevation, or use a flatten command in the scenery.cfg file to bring the ground up to match your AFCAD elevation.

For FS98 but still works:

http://www.microsoft.com/games/fligh...eryobjects.asp

Hope this helps,

[SD_BFU]

Thank you very much, it really looks like the runway and other objects are slightly above the ground level. I'll try "flatten".