richb Posted October 22, 2016 Share Posted October 22, 2016 All planes on take-off seen to want to pull to the right. What's causing this? The rudder is trim. :confused: Link to comment Share on other sites More sharing options...
vgbaron Posted October 22, 2016 Share Posted October 22, 2016 Lot's of possibilities but if it's all planes, I'd first look at the calibration of your controls. Vic P3D Rig I7 7700K @ 5.0ghz Asus Maximus X270 16G G.Skill 3600 15-15-15-18 2T EVGARTX2080ti Corsair 1000W PSU 1TB Samsung SSD for P3D - 2 - 256G OCZ Vector SSD - HAF X - Corsiar H100i V2 Liquid Cooler W10 64 Pro. Link to comment Share on other sites More sharing options...
alexzar14 Posted October 23, 2016 Share Posted October 23, 2016 I had this with my 10 year old CH pedals until I replaced it and the problem was gone. Pedals turn bad with time I guess. Another cause could be cross wind but it is subject to direction. Both P3D and XPlane are too sensitive to winds when taxiing on the ground. Link to comment Share on other sites More sharing options...
santosdasilva Posted October 24, 2016 Share Posted October 24, 2016 All planes on take-off seen to want to pull to the right. What's causing this? The rudder is trim. :confused: ohh. why is that. I never faced that. here is smooth take off and landing within my plane Link to comment Share on other sites More sharing options...
richb Posted October 26, 2016 Author Share Posted October 26, 2016 Thanks guys for your answers! But still having problem, have calibrated and re-calibrated the the stick to no avail. I flight there is no pulling to either right or left only on ground to the right. I am new to Prepar3D, never had this problem with FSX with same Saltek ST90 stick. Even now if I go into FSX it works fine. Link to comment Share on other sites More sharing options...
richb Posted November 2, 2016 Author Share Posted November 2, 2016 Finally fix the problem of planes going right on runway! What I did is a new install of Prepar3D v.3. All goes well now! :) So, if something bugs you and you can't correct it try a re-install! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.